EndRun Sonoma N12, User Manual

Page: 31 / 174

S o n o m a U s e r M a n u a l 14
C H A P T E R T W O
15 S o n o m a U s e r M a n u a l
B A S I C I N S T A L L A T I O N
Sonoma_N12 GPS(root@host:~)-> su root
You will then be prompted for the password, which is “endrun_1”, and be granted root access to the
system. To leave “super user” mode, issue the command
exit
. Issuing
exit
again will close the
telnet
session.
Using SSH
When establishing a
ssh
connection with your Sonoma, logging in directly as root is permitted.
When you log in as
root
via a
ssh
session with the Sonoma, this banner will be displayed:
*******************************************************************************
* Welcome to the Sonoma_N12 GPS SSH console on: host.your.domain
*******************************************************************************
root@192.168.1.120’s password:
Here you may log in as “root” with password “endrun_1”. After correctly entering the password
the sign on message is shown. It identifies the host system as Sonoma and shows the software part
number, version and build date:
Sonoma_N12 GPS 6010-0065-000 v 1.00 Sat Jan 19 14:17:44 UTC 2013
Sonoma_N12 GPS (root@host:~)->
This last line is the standard Sonoma N12 GPS prompt. After configuring the unit, you should
change the passwords using the Linux
passwd
command issued from the prompt.
Issuing
exit
will close the
ssh
session.
Using HTTPS
You may monitor the status of the Sonoma via the HTTPS interface. For security reasons, you may
not change any settings via the HTTPS interface. See
Chapter 7 - HTTPS
for more information.
IMPORTANT
SSH, Telnet, SNMP and HTTPS are all enabled with default passwords. To ensure security, change the
passwords or disable the protocols.
To change the passwords for SSH, Telnet and HTTPS use the Linux
passwd
command. To change the
passwords/community strings for SNMP see Chapter 6 - SNMP .
To disable Telnet, SSH, SNMP and HTTPS see Chapter 5 - Security, Disable Protocols .