EndRun Sonoma D12, User Manual

Page: 79 / 172

S o n o m a U s e r M a n u a l 62
C H A P T E R S E V E N
63 S o n o m a U s e r M a n u a l
H T T P S I N T E R F A C E
Faults: Fault Mask Page
Fault Masks
Signal Fault This field shows the current mask setting for the Signal Fault, either Masked or
Enabled. When the signal fault is Masked it will prevent a Signal Loss Fault
from occurring. Some installations may need to mask this fault when operating
the Sonoma with no CDMA signal. (An example of this would be when
configured as a Stratum 2 NTP Server.) To change the Signal Fault Mask use
the
setsigfltmask
command, or the front-panel keypad/display.
Primary and These fields will display ONLY if your Sonoma has the Dual Power Supply
Secondary Power option installed. See Chapter 10 - Options, Masking Dual Power Supply
Fault Alarms Fault Alarms for more information.
Network: IPv4 Page
This page shows the IPv4 network configuration. Fields are:
IPv4 Network Status
DHCP
By default, the Sonoma will configure itself using the Dynamic Host
Configuration Protocol (DHCP). If you need to set up static IP configuration,
you must use the
netconfig
command via the console port. Thie field will
show whether DHCP is enabled or disabled.
Address, Gateway, These fields show the settings for the IP address, gateway and netmaks.
Netmask To change these esttings use the
netconfig
command via the console port.
Network: IPv6 Page
This page shows information related to the IPv6 network parameters. For more information on IPv6
see Chapter 8 - IPv6 Information .
Network: DNS Page
This page shows the IP addresses of the primary and secondary domain name servers.
Network: MAC Address Page
This page shows the media-access-control (MAC) address for both Ethernet ports (
eth0
and
eth1
).
NTP Page
The NTP Status page shows all information related to NTP operation. Fields are:
NTP Status
Status The stratum field has several possible values:
Stratum 1: The server is fully synchronized and accurate.
Stratum 2: The server is synchronized to a Stratum 1 server.
Stratum x: The server is synchronized to a Stratum x-1 server.
Stratum 16: The server is unsynchronized. NTP clients will not use a
Stratum 16 server.