EndRun Sonoma D12, User Manual

Page: 123 / 172

S o n o m a U s e r M a n u a l 106
C H A P T E R E L E V E N
107 S o n o m a U s e r M a n u a l
F R O N T - P A N E L K E Y P A D A N D D I S P L A Y
FLSH CDMA Receiver FLASH Writes
FPGA CDMA Receiver FPGA Configuration
SIG CDMA Signal
DAC Receiver Oscillator DAC
OSC Receiver Oscillator
REF CDMA Reference Time
SYN1 Local Oscillator Synthesizer Tuning
SYN2 Local Oscillator Synthesizer
Faults: Signal Loss Fault Mask (SigFltMask)
This setting allows you to prevent a signal loss fault from creating an alarm condition. Some installa-
tions may need to mask this fault when operating the NTP server as a Stratum 2 server.
Optional Faults: Dual Power Input Fault Alarm Masks (PwrFltMask)
This setting allows you to prevent a primary or secondary power supply fault from creating an alarm
condition. See
Chapter 10 - Options, Masking Dual Power Supply Fault Alarms
for more informa-
tion.
Optional System I/O Menu (Sys_I/O)
The Sys_I/O Menu is used for configuring optional output signals. See Chapter 10 - Options, CPU
Module Options
for more information.
Optional CPU I/O Menu (CPU_I/O)
The CPU_I/O Menu is used for viewing and configuring optional output signals. See
Chapter 10
- Options, CPU Module Options for more information.
Network Menu
The Network Menu is selected from the Main Menu and provides access to Network4, Network6, and
REBOOT displays which are described below.
Network: Network4
This display provides the ability to view and modify the IPv4 network settings. The parameters
include Dynamic Host Configuration Protocol (DHCP), IP address, gateway, netmask and domain
name server (DNS) settings. Enable DHCP to allow automatic system configuration of the network
interface. When DHCP is disabled the user must provide address information.
Network: Network6
This display provides the ability to view and modify the IPv6 network settings. Refer to Chapter 8
- IPv6 Information
.