25
Checking the electrical safety
5
Checking the electrical safety
Checking of electrical safety requires different measures to be taken which
may only be undertaken by respectively authorised personnel. In doing so
the respective, pertinent VDE provisions, EN and DIN standards, in their re-
spectively valid versions, must be observed.
You must abide by the DGUV
Information 203-032 edition of May 2016 if it will be used in construction or
assembly sites. It defines special protective measures and rules of conduct
for the commissioning as well as a corresponding marking on the device.
In particular you must never use defective or damaged consumers, cable con-
nections or plug connectors, etc., (power consuming equipment). Their correct
conditions must be checked at regular intervals (see Tab. 8-1 )
Earthing
Your Generators has been designed for manual or automatic operation (remote
start) with one or more electrical consumers. To protect against electric shock
(current flow through your body), the protective separation measure with equipo-
tential bonding according to DIN VDE 0100-551: 2017-02 is used. The protective
conductor system of the attached consumer equipment takes over the function
of the potential equalisation device. The terminal (Fig. 6-2 ) is connected with this
Potential equalization device connected. An Earthing is not necessary.
Your Generators corresponds to a Version A generator according to DGUV Infor-
mation 032-203 issued in May 2016. A corresponding marking can be found on
the device (see Fig. 3-3 ):
We strongly recommend that you also comply with the requirements of DGUV In-
formation 203-032 for other purposes.
DANGER!
Dangerous electrical voltages will be present if several consumables are
connected up without a working personal safety device.
Mortal danger from electrocution
► Never operate multiple consumables from the Generators without additional
RCDs (residual current circuit breaker) for the second and each additional
consumable.
► Check the personal protection according to the check intervals given in Tab.
Summary of Contents for ECO Power Line ESE 3000 BS
Page 30: ...30 Description of the device NOTES...
Page 56: ...56 Replacement parts NOTES...
Page 57: ...57 Wiring diagram 14 Wiring diagram...
