Endress+Hauser Waterpilot FMX21, Operating Instructions Manual

Page: 99 / 144

Waterpilot FMX21 Description of device parameters
Hauser 99
Prerequisite • "Level selection" = In pressure
• "Calibration mode" = Dry -> entry
• "Calibration mode" = Wet -> display
Factory setting URL of the sensor module
Full height
Write permission Operator/Maintenance/Expert
Description Enter the height value for the upper calibration point (vessel full). The unit is selected via
the "Height unit" parameter.
Prerequisite • "Level selection" = In height
• "Calibration mode" = Dry -> entry
• "Calibration mode" = Wet -> display
Factory setting Upper range limit (URL) is converted to a level unit
Density unit
Write permission Maintenance/Expert
Description The measured pressure is converted to a height using the "Height unit", "Adjust density" and
"Process density" parameters.
Factory setting g/cm 3
Adjust density
Write permission Operator/Maintenance/Expert
Description Enter the density of the medium used to perform the calibration. The measured pressure is
converted to a height using the "Height unit" and "Adjust density" parameters.
Input: Auto dens. corr. = Off
Display: Auto dens. corr. ≠ Off
Factory setting 1.0
Process density
Write permission Operator/Maintenance/Expert