Endress+Hauser Waterpilot FMX21, Operating Instructions Manual

Page: 41 / 144

Waterpilot FMX21
Integrating device via HART ® protocol
Hauser 41
8.2 Device variables and measured values
The following measured values are assigned to the individual device variables:
Device variable code Device variable Measured value Operating mode
0 PRESSURE_1_FINAL_VALUE Pressure measured All
1 PRESSURE_1_AFTER_DAMPING Pressure af. damp All
2 PRESSURE_1_AFTER_CALIBRATION Corrected pressure All
3 PRESSURE_1_AFTER_SENSOR Corrected pressure All
4 MEASURED_TEMPERATURE_1 Sensor temp. All
8 MEASURED_LEVEL_AFTER_ SIMULATION Level before lin. Only level
9 MEASURED_TANK_CONTENT_AFTER_ SIMULATION Tank content Only level
10 CORRECTED_MEASUREMENT_ DENSITY Process density Only level
12 HART_INPUT_VALUE
1)
HART input value -
251 None (no device variable is mapped) - All (but only for quaternary variable)
1) Cannot be selected as an output
The device variables can be queried by a HART ® master using HART ® command 9 or
33.