Endress+Hauser Waterpilot FMX21, Operating Instructions Manual

Page: 37 / 144

Waterpilot FMX21 Operation options
Hauser 37
7.3 Structure of the operating menu
• Operator
Submenu: Display/operat.
Contains parameters that are needed to configure the measured value display (selecting
the values displayed, display format, etc.). With this submenu, users can change the
measured value display without affecting the actual measurement.
• Maintenance
Submenu: Setup
Contains all the parameters that are needed to commission measuring operations. This
submenu has the following structure:
• Standard setup parameters
A wide range of parameters, which can be used to configure a typical application, is
available at the start. The measuring mode selected determines which parameters are
available. After making settings for all these parameters, the measuring operation
should be completely configured in the majority of cases.
• "Extended setup" submenu
The "Extended setup" submenu contains additional parameters for more in-depth
configuration of the measurement operation, for conversion of the measured value
and for scaling the output signal. This menu is split into additional submenus
depending on the measuring mode selected.
• Maintenance
Submenu: Diagnostics
Contains all the parameters required to detect and analyze operating errors. This
submenu has the following structure:
• Diagnostic list
Contains up to 10 currently active error messages.
• Event logbook
Contains the last 10 error messages (no longer pending).
• Instrument info
Contains information for identifying the device.
• Measured values
Contains all current measured values.
• Simulation
Is used to simulate pressure, level, current and alarm/warning.
• Enter reset code
• Expert
Submenu: Expert
Contains all the parameters of the device (including those already in one of the other
submenus). The "Expert" submenu is structured by the function blocks of the device. It
thus contains the following submenus:
• System
Contains all the device parameters that do not pertain either to the measurement or to
integration into a control system.
• Measurement
Contains all parameters for configuring the measurement.
• Output
Contains all parameters for configuring the current output.
• Communication
contains all parameters for configuring the HART interface.
• Diagnosis
Contains all parameters required to detect and analyze operating errors.
7.4 Locking/unlocking operation
Once you have entered all the parameters, you can lock your entries against unauthorized
and undesired access.