Endress+Hauser Topclean S CPC30, Operating Instructions Manual, Page: 113 / 178

Topclean S 6 Commissioning
Hauser 113
To enter the menu, proceed as follows:
pH calibration "Manual data entry"
The numeric values for electrode zero point and slope are entered numerically and by hand.
⇒ ⇒
pH
7.00
Cal
Next
Info
E
Hold pH
7.00
Man. cal. with TopCal/
TopClean only if
service switch active
Cal
Next
Info
E
Hold
CHOICE
(default = bold) INFO
Calibration with
"Enter spec. buffer" Note in display
Display of the type of on-site calibration selected in the calibration settings.
025.0 °C
(–20.0 ... +150.0 °C)
Entry of temperature,
(only if "Calibrate with MTC" is selected)
07.00
(pH –2.00 ... +16.00)
ISFET:
act.value (–500 ... +500mV)
Entry of the electrode zero point
Confirm by pressing
F
.
59.16 mV/pH
(5.00 ... 99.00 mV/pH)
Entry of the electrode slope
Confirm by pressing
F
.
Accept
Cancel
Repeat calibration
End of calibration
Accept : Pressing
F
accepts the new calibration data.
Cancel : The data are not accepted and the calibration is not repeated.
Repeat calibration : The data are rejected and a new calibration is started.
Waiting for sensor response Communication to the sensor
(digital sensors with Memosens technology only)
Mycom S transmits calibration data to the sensor.
Data saved
Data NOT saved Note in display
(digital sensors with Memosens technology only)
Displays if calibration data were successfully saved to the sensor. If data saving
failed, recalibrate the sensor.
Electrode submersed? Note in display:
Is the electrode back in the medium, so that measurement can take place?