Endress+Hauser Solitrend MMP42, Brief Operating Instructions

Page: 6 / 28

Basic safety instructions Solitrend MMP42
6 Hauser
To ensure that the measuring device remains in proper operating condition throughout the
operating period:
‣
Use the device only for media to which the process-wetted materials are sufficiently
resistant.
‣
Observe the limit values in "Technical data".
Incorrect use
The manufacturer is not liable for damage caused by improper or non-designated use.
Clarification of borderline cases:
‣
For special materials and media used for cleaning, the manufacturer is happy to provide
assistance in verifying the corrosion resistance of medium-wetted materials, but disclaims
any warranty or liability.
Residual risks
Due to heat transfer from the process as well as power dissipation within the electronics, the
temperature of the electronics housing and the assemblies contained therein may rise to
70 °C (158 °F) during operation. During operation, the sensor can reach a temperature close to
the medium temperature.
Danger of burns from contact with surfaces!
‣
In the event of elevated medium temperatures, ensure protection against contact to
prevent burns.
2.3 Workplace safety
For work on and with the device:
‣
Wear the required personal protective equipment according to federal/national
regulations.
2.4 Operational safety
Risk of injury!
‣
Operate the device only if it is in proper technical condition, free from errors and faults.
‣
The operator is responsible for interference-free operation of the device.
Hazardous area
To eliminate the risk of danger to persons or the facility when the device is used in the
approval-related area (e.g. explosion protection, pressure equipment safety):
‣
Check the nameplate to verify if the device ordered can be put to its intended use in the
approval-related area.
‣
Observe the specifications in the separate supplementary documentation that is an integral
part of this manual.
2.5 Product safety
This device is designed in accordance with good engineering practice to meet state-of-the-art
safety requirements, has been tested, and left the factory in a condition in which it is safe to
operate.