RMA42
Commissioning
Hauser
35
6.5.4
Saving diagnostic events/alarms and errors
Diagnostic events such as alarms and fault conditions are saved in the device as soon as a new error
occurs or the status of the device changes. The events saved are saved every 30 minutes to the
nonvolatile device memory.
The device lists the following values in the ‘Diagnostics’ menu:
• Current device diagnosis
• Last device diagnosis
• Previous 5 diagnosis messages
List of error codes, see Section 9.2.1
!
Note!
Under certain conditions events saved over the past 30 minutes might be lost.
6.5.5
Operating hours counter
The device has an internal operating hours counter which also acts as the reference for diagnostic
events.
The operating hours can be found in the ‘
Diagnostics
’
É
‘
Operating time
’ menu item. This
information cannot be reset or changed.
6.5.6
Device reset
The following reset categories are available for a device reset.
‘
Expert
’
É
‘
System
’
É
‘
Reset
’
É
‘
Factory reset
’: reset all the parameters to the as-delivered
state; all the configured parameters are overwritten.
"
Caution!
Any user code already defined is overwritten!!! When operation is locked by a user code, this is
indicated by a lock symbol on the display.
‘
Expert
’
É
‘
System
’
É
‘
Reset
’
É
‘
User reset
’: parameters are loaded and configured in
accordance with the user setup saved; configuration currently configured or factory settings are
overwritten by the user setup.
"
Caution!
Any user code already defined is overwritten by the user code defined in the user setup!!! If no user
code was saved in the user setup, the device is no longer locked. When operation is locked by a user
code, this is indicated by a lock symbol on the display.
