RID16
Operating the field indicator
Hauser
25
5.5
Hardware settings
DIP switches inside the field indicator housing are used to enable and disable hardware write
protection. When write protection is active, parameters cannot be modified. The current write
protection status is displayed in the WRITE_LOCK parameter (Resource Block, see Section 11).
ESD - electrostatic discharge
Protect the terminals from electrostatic discharge. Failure to observe this may result in destruction
or malfunction of parts of the electronics.
To set the DIP switches, proceed as follows:
1.
Open the housing by removing the front cover.
2.
Configure the DIP switch on the electronics accordingly. Switch to ON = function enabled,
switch to OFF = function disabled.
3.
Close the housing front cover and secure it with the 4 screws.
a0011641
Fig. 15:
Hardware settings via DIP switches
1
Switch position ON
2
Switch position OFF
3
Write lock
