Endress+Hauser Proline t-mass A 150, Operating Instructions Manual, Page: 61 / 134

Proline t-mass A 150 HART Commissioning
Hauser 61
Switch-on value
Switch-off value
(Status) Assign status
Switch-on delay
Switch-off delay
Failure mode
Switch status
Invert output signal
Parameter overview with brief description
Parameter Description Selection/
User entry
Factory setting
Operating mode Specify the output as a
pulse, frequency or switch
output. • Pulse
• Frequency
• Switch Pulse
Assign pulse output Select the process variable
for the pulse output. • Off
• Mass flow
• Corrected volume flow
• FAD volume flow Off
Assign frequency output Select the process variable
for the frequency output. • Off
• Mass flow
• Corrected volume flow
• FAD volume flow
• Temperature Off
Assign switch output Select the function for the
switch output. • Off
• On
• Diagnostic behavior
• Limit value
• Status Off
Assign diagnostic
behavior Select the diagnostic
behavior for the switch
output. • Alarm
• Alarm or warning
• Warning Alarm
Assign limit Select the process variable
for the limit function. • Mass flow
• Corrected volume flow
• FAD volume flow
• Totalizer Mass flow
Assign status Select the device status for
the switch output. Low flow cut off Low flow cut off