Endress+Hauser Proline t-mass A 150, Operating Instructions Manual, Page: 50 / 134

Commissioning Proline t-mass A 150 HART
50 Hauser
Parameter overview with brief description
Parameter Description Selection/
User entry
Factory setting
Select gas type Select the gas type for the
measurement application. Gas type choose list
• Air
• Argon Ar
• Carbon dioxide CO2
• Nitrogen N2 Air
10.4.2 Specifying the process pressure
Navigation path
"Setup" menu → Process pressure
Parameter overview with brief description
Parameter/ Description Selection/
User entry
Factory setting
Process pressure Process pressure value for
calculating pressure-dependent gas
properties 0.5 to 41.6 bar a
(7.3 to 603 psi a) Country-dependent:
1.0130 bar a
(14.692 psi a)
10.4.3 Determining the installation factor
Navigation path
"Setup" menu → Installation factor
Parameter overview with brief description
Parameter Description Selection/
User entry
Factory setting
Installation factor The factor is multiplied by
the mass flow to correct
sub-optimum installations 0 to 9 1