Endress+Hauser Proline t-mass A 150, Operating Instructions Manual, Page: 21 / 134

Proline t-mass A 150 HART Installation
Hauser 21
max. 2 × 90°
4 mm
4 mm
A0017227
1. Unscrew the securing screw using an Allen key.
2. Rotate the housing in the desired direction.
3. Firmly tighten the securing screw.
6.2.5 Turning the display module
Esc
A0017228
1. Remove the cover of the electronics compartment.
2. Pull out the display module with a gentle rotational movement.
3. Turn the display module to the desired position: Max. 4×90° in each direction.
4. Feed the ribbon cable into the gap between the housing and main electronics module
and plug the display module into the electronics compartment and turn it until it
engages.
5. Screw the cover of the electronics compartment back on.
6.3 Post-mounting check
Is the device damaged (visual inspection)? 
Does the measuring device conform to the measuring point specifications?
For example:
• Process temperature
• Process pressure (refer to the chapter on "Material load curves" of the "Technical Information"
document)
• Ambient temperature range
• Measuring range →  95
