Basic safety instructions
Proline Promass F 200 HART
8
Hauser
2
Basic safety instructions
2.1
Requirements for the personnel
The personnel for installation, commissioning, diagnostics and maintenance must fulfill the following
requirements:
►
Trained, qualified specialists must have a relevant qualification for this specific function and task
►
Are authorized by the plant owner/operator
►
Are familiar with federal/national regulations
►
Before beginning work, the specialist staff must have read and understood the instructions in the
Operating Instructions and supplementary documentation as well as in the certificates
(depending on the application)
►
Following instructions and basic conditions
The operating personnel must fulfill the following requirements:
►
Being instructed and authorized according to the requirements of the task by the facility's owner-
operator
►
Following the instructions in these Operating Instructions
2.2
Designated use
Application and media
The measuring device described in these Instructions is intended only for flow measurement of
liquids and gases.
Depending on the version ordered, the measuring device can also measure potentially explosive,
flammable, poisonous and oxidizing media.
To ensure that the measuring device remains in proper condition for the operation time:
►
Only use the measuring device in full compliance with the data on the nameplate and the general
conditions listed in the Operating Instructions and supplementary documentation.
►
Based on the nameplate, check whether the ordered device is permitted for the intended use in
the hazardous area (e.g. explosion protection, pressure vessel safety).
►
Use the measuring device only for media against which the process-wetted materials are
adequately resistant.
Incorrect use
Non-designated use can compromise safety. The manufacturer is not liable for damage caused by
improper or non-designated use.
NOTICE
Danger of breakage of the measuring tube due to corrosive or abrasive fluids.
Housing breakage due to mechanical overload possible!
►
Verify the compatibility of the process fluid with the measuring tube material.
►
Ensure the resistance of all fluid-wetted materials in the process.
►
Observe the specified maximum process pressure.
Verification for borderline cases:
►
For special fluids and fluids for cleaning, Hauser is glad to provide assistance in verifying
the corrosion resistance of fluid-wetted materials, but does not accept any warranty or liability
as minute changes in the temperature, concentration or level of contamination in the process
can alter the corrosion resistance properties.
Residual risks
!
WARNING
Danger of housing breaking due to measuring tube breakage!
►
In the event of a measuring tube breakage for a device version without rupture disk it is possible
for the pressure loading capacity of the sensor housing to be exceeded. This can lead to rupture
or failure of the sensor housing.
