Endress+Hauser Proline Promass E 300 HART, Operating Instructions Manual

Page: 75 / 212

Proline Promass E 300 HART System integration
Hauser 75
Parameter Description Selection / User entry
Burst variable 0 For HART command 9 and 33: select the HART device variable
or the process variable. • Mass flow
• Volume flow
• Corrected volume flow
*
• Target mass flow
*
• Carrier mass flow
*
• Density
• Reference density
*
• Concentration
*
• Temperature
• Totalizer 1
• Totalizer 2
• Totalizer 3
• HBSI
*
• HART input
• Percent of range
• Measured current
• Primary variable (PV)
• Secondary variable (SV)
• Tertiary variable (TV)
• Quaternary variable (QV)
• Not used
• Target volume flow
*
• Carrier volume flow
*
• Target corrected volume flow
*
• Carrier corrected volume flow
*
• Reference density alternative
*
• GSV flow
*
• GSV flow alternative
*
• NSV flow
*
• NSV flow alternative
*
• S&W volume flow
*
• Water cut
*
• Oil density
*
• Water density
*
• Oil mass flow
*
• Water mass flow
*
• Oil volume flow
*
• Water volume flow
*
• Oil corrected volume flow
*
• Water corrected volume flow
*
Burst variable 1 For HART command 9 and 33: select the HART device variable
or the process variable. See the Burst variable 0 parameter.
Burst variable 2 For HART command 9 and 33: select the HART device variable
or the process variable. See the Burst variable 0 parameter.
Burst variable 3 For HART command 9 and 33: select the HART device variable
or the process variable. See the Burst variable 0 parameter.
Burst variable 4 For HART command 9: select the HART device variable or the
process variable. See the Burst variable 0 parameter.
Burst variable 5 For HART command 9: select the HART device variable or the
process variable. See the Burst variable 0 parameter.
Burst variable 6 For HART command 9: select the HART device variable or the
process variable. See the Burst variable 0 parameter.
Burst variable 7 For HART command 9: select the HART device variable or the
process variable. See the Burst variable 0 parameter.
Burst trigger mode Select the event that triggers burst message X. • Continuous
• Window
*
• Rising
*
• Falling
*
• On change
Burst trigger level Enter the burst trigger value.
Together with the option selected in the
Burst trigger mode
parameter the burst trigger value determines the time of burst
message X.
Signed floating-point number