SmarTec S CLD 132 PROFIBUS-PA/-DP
Safety instructions
4
EHauser
1
Safety instructions
1.1
Designated use
SmarTec S CLD 132 PROFIBUS
®
is a measuring system for measuring conductivity.
The PROFIBUS
®
interface allows the device to be operated using the Operating
program Commuwin II at the PC via a PROFIBUS
®
interface.
Using the device for any application other than that described could call into question
the safety of persons, and of the entire measuring system, and is therefore not
permitted.
The manufacturer accepts no liability for damage resulting from incorrect use or use
other than that designated.
1.2
Installation, commissioning and operation
Note the following points:
•
Installation, electrical connection, commissioning, operation and maintenance of the
measuring system must be carried out exclusively by specially trained technical
personnel.
This personnel must be authorised to perform such work by the system operator.
•
Technical personnel must have read and understood these Operating Instructions
and must adhere to them.
•
Before commissioning the entire measuring point, check all the connections for
correctness. Ensure that electrical cables and hose connections are not damaged.
•
Do not commission damaged products. Protect them against inadvertent
commissioning. Mark the damaged product as defective.
•
Faults at the measuring point may only be rectified by authorised and specially trained
personnel.
•
If faults cannot be rectified, you must take the products out of operation and protect
them against inadvertent commissioning.
•
Repairs not described in these Operating Instructions may only be carried out directly
at the manufacturer’s or by the Hauser service organisation.
1.3
Operational safety
The transmitter has been designed and tested according to the state of the art and left
the factory in perfect functioning order.
Appropriate regulations and European standards have been taken into consideration.
As the user, you are responsible for ensuring the following safety regulations are
observed:
•
Installation regulations
•
Local standards and regulations
1.4
Return
If the device has to be repaired, please return it
Vi>i`
to your nearest
Hauser sales centre.
Please use the original packaging if possible.
Please enclose a duly completed Dangerous Goods Sheet (copy second-last page of
these Operating Instructions) with both the packaging and the transportation
documents.
Summary of Contents for PROFIBUS-DP
Page 2: ......