Endress+Hauser Nivector FTI26, Operating Instructions Manual

Page: 22 / 28

Maintenance Nivector FTI26
22 Hauser
9 Maintenance
No special maintenance work is required.
9.1 Cleaning
The sensor must be cleaned if necessary. Cleaning can also be performed while installed.
Care must be taken to ensure that no damage occurs to the sensor in the process.
10 Repair
10.1 General information
Repair is not envisaged for this measuring device.
10.2 Spare parts
No spare parts are provided for this measuring device.
10.3 Return
The requirements for safe device return can vary depending on the device type and
national legislation.
1. Refer to the website for more information:
http://www.endress.com/support/return-material
2. Return the device if repairs or a factory calibration are required, or if the wrong
device was ordered or delivered.
10.4 Disposal
If required by the Directive 2012/19/EU on waste electrical and electronic equipment
(WEEE), the product is marked with the depicted symbol in order to minimize the dis-
posal of WEEE as unsorted municipal waste. Do not dispose of products bearing this
marking as unsorted municipal waste. Instead, return them to Hauser for dis-
posal under the applicable conditions.
11 Accessories
• Accessories can be ordered with the device (optional) or separately.
• The adapters are also available with inspection certificate 3.1 EN10204. For more
information on process adapters and weld-in adapters, please refer to the
supplementary documentation .