Memosens CFS51
Mounting
Hauser
17
5. Fix the securing plate with the 4 M5 screws in a cross-wise sequence.
5.2.3
Mounting the spacer on the panel
The spacer, together with the ring clip, are used to secure the sensor. The spacer must be
mounted at the level of the sensor housing.
1. Hold the spacer up at the mounting point above the assembly. In doing so, pay
attention to the dimensions → 5, 11.
2. Mark the 2 boreholes on the panel. In doing so, pay attention to the dimensions
3. Drill the holes.
4.
A0048147
Fix the spacer on the panel with 2 M5 screws.
5.2.4
Mounting the sensor with the assembly
The sensor can be installed in the assembly both with the pre-installed clamping ring and
without the installed clamping ring.
Preparatory steps for the sensor with the installed clamping ring:
1.
1
2
A0048148
1
Union nut
2
Ring clip
Slide the union nut onto the sensor from above (over the fixed cable).
2. Slide the ring clip onto the sensor from above (over the fixed cable).
