Endress+Hauser Levelflex M FMP40, Operating Instructions Manual

Page: 73 / 92

Levelflex M FMP40 with HART/4...20 mA Troubleshooting
Hauser 73
9.5 Return
The following procedures must be carried out before a transmitter is sent to Hauser e.g.
for repair or calibration:
• Remove all residue which may be present. Pay special attention to the grooves for seals and
crevices which could contain fluid residues. This is particularly important if the substance is
hazardous to health, e.g. flammable, toxic, caustic, carcinogenic, etc.
• Always enclose a duly completed "Declaration of Contamination" form (a copy of the
"Declaration of Contamination" is included at the end of these Operating Instructions). Only then
can EHauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example a safety data sheet as per
EN 91/155/EEC.
Additionally specify:
• The chemical and physical properties of the fluid
• A description of the application
• A description of the error that occurred (specify error code if possible)
• Operating duration of the device
9.6 Disposal
In case of disposal please separate the different components according to their material consistence.
9.7 Software history
9.8 Contact addresses of Hauser
Contact addresses can be found on our homepage: www.endress.com/worldwide. If you have any
questions, please do not hesitate to contact your Hauser representative.
Date Software version Software modifications Documentation Description of
Instrument Functions
02.2008 01.08.00 Original-Software.
Bedienbar über:
– FieldCare
– HART-Communicator 375 mit Rev. 1, DD 1.
BA363F/00/en/03.08
71060231
BA363F/00/en/03.09
71074941
BA366F/00/en/01.08
71060890