Proline Promass 80
Operation
Hauser
31
5
Operation
5.1
Display and operating elements
The local display enables you to read all important variables of the simulation directly at the
measuring point and configure the device using the function matrix.
The display consists of two lines; this is where measured values and/or status variables (direction
of flow, empty pipe, bar graph etc.) are displayed. You can change the assignment of display lines to
different variables to suit your needs and preferences (
"Description of Device Functions"
manual).
a0001141
Fig. 26:
Display and operating elements
1
Liquid crystal display
The backlit, two-line liquid crystal display shows measured values, dialog texts, fault messages and notice messages.
The display as it appears when normal measuring is in progress is known as the HOME position (operating mode).
– Upper display line: shows primary measured values, e.g. mass flow in [kg/h] or in [%].
– Lower display line: shows additional measured variables and status variables, e.g. totalizer reading in [t], bar
graph, measuring point designation.
2
Plus/minus keys
– Enter numerical values, select parameters
– Select different function groups within the function matrix
Press the +/– keys simultaneously to trigger the following functions:
– Exit the function matrix step by step
HOME position
– Press and hold down +/– keys for longer than 3 seconds
Return directly to HOME position
– Cancel data entry
3
Enter key
– HOME position
Entry into the function matrix
– Save the numerical values you input or settings you change
Esc
E
+
-
1
3
2
+48.25 xx/yy
+3702.6 x
