Endress+Hauser Fieldgate FXA520, Operating Instructions Manual

Page: 77 / 108

Fieldgate FXA520 7 Viewing Information (User Mode)
Hauser 75
7.2.3 Device details
Device details are accessed by pressing the
Tag
in the device overview. Exactly which details are
presented depends upon the device type.
Static data
This dialog shows the static data read from a HART device. Table 7-2 describes the parameters.
Table 7-2: Static data parameters
Dynamic data/status
This dialog shows the dynamic data and status read from a HART device. Table 7-3 describes the
parameters.
Table 7-3: Dynamic parameters and status
Parameter Description
Tag
Tag set in device
Descriptor
User description set in device
Message
Additional user text description in device
Manufacturer
Manufacturer of the device
Device Type
Manufacturer’s device designation
Device ID
Device serial number
Channel/Short ...
Left: Fieldgate channel number, right: HART address (= 10 for multiplexer)
Final Assembly ...
Manufacturer’s device assembly code
Unique Identifier
Device identifier as per HART specifications, e.g. "11070fb7f9"
– Positions 1+2 (11 = manufacturer, here Hauser)
– Positions 3+4 (70 = device, Cerabar S)
– Positions 5...10 (fb7f9 = serial number of the device, this is manufacturer-specific)
Date Code
Date of manufacture as per HART specifications
Static Data...
Time stamp showing when data was scanned from the device
Parameter Description
PV - Loop Current
4 - 20 mA current value set for device
PV - % of Range
Measured value as a percentage of the measuring range set in device
Status
Simple device status according to HART specification plus 2 bytes (hex) information
– Error: "ERROR", Warning: "WARN", Normal function: "OK"
2 bytes hex status code plus plain text, e.g.: 0x00 0x08 – Device Status: Loop Current Fixed
Additional Device
Status (raw)
Extended Device Status as hex code as read by Command 48, see Chapter 6.4.5.