Endress+Hauser Fieldgate FXA520, Operating Instructions Manual

Page: 50 / 108

5 Commissioning Fieldgate FXA520
48 Hauser
4 Now configure any other communication parameters, e.g. e-mails, as described in Chapter 5.5.
5 You may now wish to configure additional Fieldgate device functions, e.g. limit values,
scanning cycle, in the Fieldgate Web server as described in Chapter 6.
6 When configuration is complete, select
Settings => Special
to restart the system and register
the changes
– In the
System Restart
dialog, check the "Confirm System Restart" box and press
Send
– The Fieldgate restarts with the changes made via the service interface permanently stored
7 When the restart is complete, close the Web browser, unplug the service connector and switch
off the Fieldgate.
8 Insert the SIM card in the recepticle provided and close the front panel.
9 Ensure that the antenna is connected and switch on the Fieldgate. Connect the Fieldgate via
the host computer as described in Chapter 5.4.4 or 5.4.5.
5.4.3 Set up the dial-up connection in your computer
A dial-up connection can only be set up if the PC has a modem and the GSM provider supports CSD.
Before you set up the dial-up connection, make sure that the GSM parameters have been configured
as described in Chapter 5.4.2.
1 Start the
New Connection Wizard
and follow the procedure in Chapter 5.1.4
– In the
Select a Device
dialog, select the analog or GSM modem
– In the Connection Name dialog, enter e.g. Fieldgate GSM Connection
– In the
Number to Connect
dialog, enter the phone number of the Fieldgate
– All other settings are identical
2 In the
Network Connections
dialog (
Start > Settings > Network Connections
), right-
click on the new connection, e.g. Fieldgate Analog Connection and select
Properties.
The
Properties
dialog opens
:
3 Select the modem used with the connection, then the
Networking
tab
– Now select
Internet Protocol (TCP/IP)
and press
Properties
4 In the
Properties
dialog that now appears press the
Advanced...
button, the dialog
Advanced Properties
opens at the
General
tab
– Deactivate the "
Use default gateway on remote network
" option, press
OK
– Close all dialogs with
OK
.