ControlCare Panel PC SPC150
1 Safety
Hauser
3
1
Safety
1.1
Designated used
ControlCare Panel PC SPC150 is an industrial computer with integrated 12" touchscreen as well as
preinstalled P View Web-client. The Panel PC may be used only as described in this manual and
only with the components recommended by Hauser, which where necessary must have
appropriate certification.
1.2
Installation, commissioning and operation
ControlCare Panel PC SPC150 must be installed, connected, operated and maintained according to
the instructions in this manual: personnel must be authorised and suitably qualified.
Prerequisites for proper and safe operation of the product are its correct transport, correct storage,
installation and mounting as well as careful operation and maintenance.
1.3
Operational safety
Operational environment
ControlCare Panel PC SPC150 fulfils the harmonised, European standards (EN) for the various
environments in which is designed to operate. The permissible operating conditions as described in
the technical data must be upheld.
Explosion hazardous areas
The device may not be installed in explosion hazardous areas.
Repair
Do not open the device housing. It contains no components that need be maintained or can be
repaired by the user. In the event of a fault or defect, return the device to the manufacturer. Opening
the device housing invalidates the guarantee.
1.4
Declaration of conformity
CE Mark
ControlCare Panel PC SPC350 fulfils the requirements of the EU Directive 89/336/EEC
"Electromagnetic Combatibility" (EMC Directive).
• Interference emmision:
EN 50022:1998 Classe A (Product standard ITE)
EN 50011:1998 Group 1 Classe A (Product standard ISM)
• Interference Immunity:
IEC 61000-6-2: 1999
Interference Immunity: Industrial Environment
4
A declaration in accordance with the above-mention standards has been issued and can be acquired
from Hauser Process Solutions AG.
1.5
Technical improvement
Hauser reserves the right to make technical improvements to its software and equipment
at any time and without prior notification. Where such improvements have no effect on the
operation of the equipment, they are not documentated. If the improvements effect operation, a
new version of the operating instructions is normally issued.
