Description of parameters
Cerabar S 4 to 20mA HART
14
Hauser
P01-MIDxxxxx-19-xx-xx-EN-005
Fig. 6:
BASIC SETUP function group for the "Pressure" measuring mode
*
*
1)
2)
1)
*
Parameters marked with an asterisk "*"
are not always displayed. The display
depends on the settings of other parameters,
see the following Table.
LANGUAGE
Pressure
BASIC SETUP
DISPLAY
SETTINGS
POSITION ADJUSTMENT
OPERATING MENU
GROUP SELECTION
Measured value
MEASURING MODE
EXTENDED SETUP
PRESS. ENG. UNIT
CUSTOMER UNIT P
CUST. UNIT FACT. P
SET LRV
DAMPING VALUE
GET LRV
GET URV
SET URV
1) Display via on-site display only
2) Display via digital communication
Level (not
for PMP71 with MID)
provided
Table 4: (GROUP SELECTION
) OPERATING MENU
SETTINGS
BASIC SETUP "Pressure"
Parameter name
Description
Prerequisite
:
• MEASURING MODE = Pressure
Note:
See also
– Page 11, Table 3: QUICK SETUP
– Page 17, Table 13: EXTENDED SETUP
– Page 29 ff, Table 23: PROCESS VALUES
– Page 8 ff, Section 4 "Pressure measurement".
MEASURING MODE
Options
Select the measuring mode.
The operating menu is structured according to the selected measuring mode.
!
Note!
When the measuring mode is changed, no conversion takes place. The device has to be
recalibrated if the measuring mode is changed.
Prerequisite:
• Digital communication
Options
:
• Pressure
Factory setting
• Pressure
