Security
SPECORD PLUS
8
3.2
Requirements for the operating personnel
The device must only be operated by qualified specialist personnel instructed in the
use of the device. This instruction also include teaching the contents of this user
manual and of the user manuals of the connected system components. We recom-
mend training by qualified employees of Analytik Jena or its representatives.
In addition to the safety instructions in this user manual, the general applicable
safety and accident prevention regulations of the respective country the device is op-
erated in must be observed and adhered to. The operator must ensure the latest ver-
sion of these regulations.
The user manual must be accessible to the operating and service personnel.
3.3
Safety instruction – explosion protection
The device may not be operated in an explosive environment.
3.4
Safety instructions: during operation
3.4.1
General safety instructions during operation
The operator must make sure that the device and its safety equipment is in sound
condition each time before starting up the device. This applies especially after any
modification or adaptation of the device or any repair.
Observe the following:
¡
The device may only be operated if all protective equipment (e.g., covers for elec-
tronic components) is in place, properly installed and fully operational.
¡
The sound condition of the protection and safety equipment must be checked
regularly. Any defects must be corrected as soon as they occur.
¡
Protective and safety equipment must never be removed, modified or switched
off during operation.
¡
Ensure that no liquid enters the interior of the device, for example at cable con-
nections. There is a danger of electric shock.
¡
Caution when handling glass components. Risk of broken glass and therefore risk
of injury!
¡
Never look into the lamp directly or indirectly, e.g., via a mirror. For this reason,
switch off the device when replacing the lamp. A risk of eye damage due to UV
radiation is present.
3.4.2
Safety instructions – electrical equipment
Lethal voltages may occur in the device! Contact with live components may cause
death, serious injury or painful electrical shock.
¡
The power plug must be connected to a proper power outlet to ensure that the
device meets protection class I (ground connector). The device may only be con-
nected to power sources whose nominal voltage is the same as that on the rating
plate of the equipment. Do not replace the removable power cable of the device
with a power cable that does not meet the specifications (with no protective
ground conductor). Extensions of the supply cable are not permitted!
