Nitrogen analysis with the CLD 5000
multi EA 5000
46
7.2
Installation
NOTICE
Connecting or disconnecting electrical contacts may damage the sensitive electronic
components of the basic module and of the detection module.
¡
Always connect the modules to power when they are switched off.
NOTICE
The detection module is equipped with a pump that can disrupt the function of other
optical detection modules or lead to serious errors.
¡
Always connect the detection module as the last in any series of the detectors.
}
Install the detection module as the last in any series of detectors.
}
Install the absorber on the rear of the device:
– Fasten the two holding clamps with the supplied screws.
– First press the absorber into the upper holding clamp and then into the lower
one.
– Connect hose 6 to the absorber. Do not pull the hose out of the device!
1
2
3
Figure 23Absorber
1 Hose 6 connection
2 Holding clamp
3 Absorber
