Endress+Hauser Analytik Jena multi EA 4000, Operating Manual

Page: 67 / 151

multi EA 4000 Commissioning
67
1 Boat storage
2 Hexagon socket screws
with washers
3 Cover for sliding rod
Figure 40 Retrofit kit for FPG 48 to use the boat storage
1. Unscrew the stop plate of the guide rail (1).
2. Remove the two hexagon socket screws (2).
3. Using the screws supplied screw the boat storage
loosely to the FPG 48.
4. Slide the hook cover under the block.
5. Place the ceramic hook into the guide rail of the au-
tosampler.
6. Place the long sliding rod onto the hook until the pin
engages in the slot.
7. Adjust the ceramic hook in the start position. The
hook tip must be flush with the right-hand edge of the
left-hand boat position (here position 37).
Place a straight paper or plastic strip (e.g. a ruler)
against the edge and align the ceramic hook with it.
8. Move the cover until the rear end of the sliding rod
touches the stop plate at the end of the cover. (See
image section for stop plate)
9. Tighten the hexagon socket screws at the block fin-
ger-tight and thereby clamp the cover in its adjusted
position.
When tightening the screws align the boat storage
parallel to the guide rail.
10. Start the multiWin software and log in as administrator.
11. Select the menu command D
EVICE

D
EVICE
– EDIT.