Safety instructions
Biometra TAdvanced
14
Version 02_20
Do not operate the device near sources of strong electromagnetic radiation (for
example, an unshielded, deliberately operated high frequency source), as these
may affect proper operation of the device.
2.6.4
Handling of samples, auxiliary and operating materials
The operator is responsible for the selection of substances used in the process as well
as for their safe handling. This is particularly important for radioactive, pathogenic,
infectious, poisonous, corrosive or otherwise dangerous substances. For details contact
the safety officer responsible for your location. When handling dangerous substances
local safety codes and guidelines must be observed. The following general notes do
not replace the specific local regulations or the regulations in the EC safety data sheets
of the manufacturers for the auxiliary and operating materials.
The following has to be observed:
Protective goggles and rubber gloves have to be worn when handing reagents.
If only a few samples are treated, an (empty) tube of the same height must
additionally be placed at each corner position of the block. If the number of
samples in the block is too low, there is a risk of the tubes being damaged and
sample liquid leaking out.
For your own safety, please observe the potential infectious qualities of the
examined biological material.
2.7
Safety instructions
–
maintenance and repair
The Biometra TAdvanced is usually repaired by the service department of Biometra
GmbH or its authorized and trained specialist personnel. Unauthorized repairs can
damage the device. Therefore, the operator may generally only carry out the tasks
listed in section "Maintenance and care" p. 119.
The following has to be observed:
The exterior of the device may only be cleaned with a damp, not dripping, cloth
after the device has been switched off.
Do not use alcohol (e.g., methanol or ethanol), organic solvents or abrasives to
clean the device.
Any maintenance on the device may usually only be carried out in the switched-off
condition (unless stated otherwise).
2.8
Behavior during emergencies
In case of danger or accidents, immediately switch off the Biometra TAdvanced using
the main switch on the equipment back plate. Disconnect the mains plug from the
power supply!