Lullaby Wall Light
Safety Warnings
INSTRUCTION MANUAL
• This product is only suitable for connection to 240V~50Hz supply, indoor use only and is
not
suitable for a
Bathroom location.
• Before installing your light fitting always switch off the mains supply and remove the appropriate fuse or
switch off the appropriate circuit breaker before commencing installation.
• This is a Class I fitting, and
must
be connected to Earth.
The terminal blocks are supplied according to
requirements of the fitting.
• Never fit bulbs of a higher wattage than those specified on the label (as these may cause overheating and
damage the fitting).
• This product contains delicate parts. Take care during installation and maintenance to avoid breakages
• If you are in any doubt about your competence please consult a qualified electrician.
• If any modification is made it will invalidate the warranty and may render the product unsafe.
Endon Lighting, LS9 0SE
Assembly/ User Instructions
Please read these instructions carefully before fitting and retain for reference.
Check the packaging and make sure that you have all the required parts.
Follow each assembly step in order to prevent incorrect assembly.
Ensure that the product is fully assembled as illustrated before use.
The Light pack contains:
Light fitting.
Terminal connection block(s).
Fixing pack.
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
Before you start
Care Information
Allow 10 minutes to cool before replacing, adjusting or cleaning.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
56653-Lullaby-WB 20150814
1. Decide on the position of the light fitting / or remove existing light fitting. Take a note of the position of the
electrical connections. Ensure there is a solid mounting surface, preferably a wooden joist or joist bridge to
support the weight of the light fitting.
2. Unscrew the finial at the bottom, remove nut and washer leaving threaded tube in place. Retain these parts.
Remove bowl sconce. Fit rubber grommet shown if not in place in cable entry hole. Use the fixing bracket as
a template to mark the screw holes and secure to the wall with appropriate screw fixings, making sure the
bracket is horizontal.
3. Support your fitting and connect the house wiring to the terminal block. When you are sure of the connections
wrap the Terminal Block and overlap the wiring both sides with 2 layers of insulation tape.
NOTE: This is a
Class I fitting and must be earthed
.
4. Re-fit the sconce, washer,nut, and Finial
