• Re-connect the moulded male / female connectors from
the demister – (A).
• Re-fit the mirror front making sure any silicone seals are
correctly positioned – to protect the fitting against water
ingress and that no cables are trapped -then secure in
position with the 4 screw assemblies removed above.
• Turn on the power and test the proximity switch.
Commissioning
Instruction leaflet
Kalamos Mirror
EL-KALAMOS
(56420)
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
Endon Lighting LS9 0SE
• We recommend cleaning with a soft dry cloth. Do not use
solvents or abrasive cleaners as these could damage the
finish.
• Mirror – Use a damp cloth or a propriety glass cleaner.
Do not use abrasive materials as these will damage the
finish.
Live Voltages may be present in this unit even when turned of or when completely disconnected.
For your safety,
always switch off the supply before changing lightbulbs, or cleaning.
The mirror must be replaced immediately should it become cracked or damaged. This fitting must
not be used without the mirror in place.
Replace Cracked
Shade
• This operates on a proximity sensor. Pass a hand over the
mirror surface, the sensor will activate, and the demister
pad will warm the mirror surface.
• The demisting effect will spread approximately 10 - 20%
further than the pad itself.
Demister Operation
Iss.3 03082016
Check that...
• You have correctly identified the wires
• The connections are tight
• No loose strands have been left out of the connection
block.
Having correctly identified the wiring from your existing light
fitting, pull the wire through the hole and connect to the
connection block inside the product in the following way:
Wiring
SUPPLY
NEUTRAL
LIGHT FITTING
BLUE (N)
EARTH (GREEN/YELLOW)
GREEN/YELLOW
BROWN (L)
SWITCHED LIVE
