EDM01-33v1 DAG_7.5G4_Card_User_Guide
©2008 Endace Technology Ltd. Confidential - Version 1 - November 2008
29
Viewing the DAG card status
Interface Status
When you have configured the card according to your specific requirements you can view
the interface statistics to check the status of each of the links using:
dagconfig –d0 –s
(where "0" is the device number of the DAG card you wish to capture data from)
For more information see
dagconfig
(page 28).
There are multiple printout levels. The statistics displayed below are printout level 0.
Example outputs are shown below:
Note:
“
1
” indicates the condition is present on the link “
0”
indicates the condition is not
present on the link.
Ethernet
Port
pll_lock
lock
los
reset_done
link
lof
A
1
1
0
0
1
0
B
1
1
0
0
1
0
C
1
1
0
0
1
0
D
1
1
0
0
1
0
A definition of each of the ETHERNET status conditions up to printout level 2 is described
below.
Condition
Description
Link
The link is fully validated.
Lock
Card is locked to the incoming signal and can capture data.
Lof
Loss of frame. Indicates LOF has been asserted for more than 3 secs.
Los
Loss of signal. Indicates there is either no signal at the receiver or the optical
signal strength is too low to be recognized.
peer_link
The peer link is up.
pll_link
Phase Lock Loop locked.
Port
Indicates the port the status conditions apply to.
remote_fault
Remote error indicator.
reset_done
Translater reset finished.
Summary of Contents for DAG 5.2X
