Endace Measurement Systems Limited
http://www.endace.com
EDM01.05-04r1 DAG 3.6GE User Manual
Copyright, all rights reserved.
3
Revision 7. 22 September 2005.
1.3 DAG 3.6GE Card Architecture
, continued
Figure
Figure 1-2 shows the DAG 3.6GE Card major components and process
flow.
Figure 1-2. DAG 3.6GE Card Major Components and Process Flow.
DAG card as a
NIC card
The DAG 3.6GE card has a single 10/100/1000 Mbps Copper Ethernet
port. This is configured as if the DAG was a NIC, and can be connected to
a hub, switch or router port directly.
The DAG 3.6GE can also be connected to a NIC card using an Ethernet
cross-over cable. The DAG captures all packets received on this port,
similar to a NIC in promiscuous mode.
1.4 DAG 3.6GE Card Extended Functions
Description
The DAG 3.6GE functionality can be extended in many ways.
Contact the Endace customer support team at
enable effective use of extended functions.
1.5 DAG 3.6GE Card System Requirements
Description
The DAG 3.6GE and associated data capture system minimum operating
requirements are:
•
PC, at least Pentium II 400 MHz, Intel 440BX, GX or newer chip
set
•
256 MB RAM
•
At least one free PCI free slot with 3.3V and 5V power
•
Software distribution free space of 30MB
Continued on next page
