Encore Networks EN-1000 Series, Quick Configuration Manual

Page: 4 / 8

Page 4 EN-1000™ Quick Configuration Guide
Go to Top
Document
c Select IP Passthrough to provide connection between an existing non-wireless
router and a network. Connect the non-wireless router to the EN-1000’s LAN port.
Note: The device connected to the EN-1000’s LAN port will see the IP address of the
cellular port or of the WAN port.
❖
The screen displays parameters for this device mode. See Configuring the
EN-1000 for IP Passthrough on page 6.
d Select VRRP Backup to use the EN-1000 as a backup router in a VRRP set.
❖
The screen displays parameters for this device mode. See Configuring the
EN-1000 for VRRP Backup on page 6.
Configuring the EN-1000 for Cell Failover
Make sure you have performed step 6a on page 3.
Application Configuration Screen to use EN-1000 in Cell Failover Mode
(WAN Protocol Displayed as Static)
7 Do the following when the EN-1000 will provide cell failover:
a Modify the following parameters, if required:
• Device Name
• LAN IP
• LAN Netmask • LAN DHCP Server
• enCloud Enabled
b Pull down the menu at the right of the WAN Protocol field, and select the EN-1000’s
WAN protocol ( DHCP Client , PPPoE , or Static ).
❖
Parameters are displayed for the selected WAN Protocol (as indicated in the
following table).