USER MANUAL
ENCOM PULSE Link
© 2012-2015 Encom Wireless Data Solutions Inc.
For ENCOM PULSE Link Version 2.2.6
Page 16
Connecting to a PULSE Radio
To connect to an ENCOM PULSE radio, follow the procedure listed below:
1. Run the ENCOM PULSE Link application on your computer.
2. The
at the top right-hand corner of the application's window will prompt you to
connect to a radio.
3. Power the PULSE radio with the provided wall mount power adapter, and then connect the
radio to your computer with the included USB cable.
4. ENCOM PULSE Link will detect the radio and attempt to communicate with it.
5. When PULSE Link is able to communicate with the radio, it will automatically retrieve its
configuration settings.
Note that when the status bar is red, you should not disconnect the USB cable from the radio,
nor should you remove power from the radio. Doing so could prevent the radio from being
able to communicate properly over the serial port (or the FSK port for FSK radios). If this
happens, you may have to use PULSE Link again to restore the radio's configuration.
Summary of Contents for iPULSE R
Page 2: ......
