23/04/2019
6 / 43
Version 1.09
1.1.4
Safety Recommendations and Warnings
Ensure that the power supply is disconnected from the board before inserting or removing a Mars
module, connecting interfaces, replacing SD-Cards and batteries, connecting jumpers, etc.
Take special care with the mounting orientation of Mars modules
–
they can fit in the connectors both
ways round. The base board and the module may be damaged if inserted the wrong way and powered
up.
Touching the capacitors of the DC-DC converters can lead to voltage peaks and permanent damage.
Over-voltage on power or signal lines can cause permanent damage.
1.1.5
Electro-Static Discharge
Electronic boards are sensitive to Electro-Static Discharge (ESD). Please ensure that the product is
handled with care and only in an ESD protected environment.
1.1.6
EMC
This is a Class A product and is not intended to be used in domestic environments. The product may
cause electromagnetic interference in which appropriate measures must be taken.
1.2
Deliverables
•
Mars PM3 Board
•
Mars PM3 user manual (this document)
•
Mars PM3 schematics1
•
Mars PM3 IO Netlength sheet1
1.3
Accessories
•
Mars MX1, MX2, AX3, ZX2, ZX3 or MA3 module
•
12V Power Supply
•
USB 3.0 A to B cable
•
JTAG Adapter board for FX3 and FPGA debugging (JTAG-PM3)
Warning
Enclustra FMC AN1 board not usable when using Enclustra Mars heat sink:
If an Enclustra Mars heat sink is mounted on the inserted module, the FMC AN1
Board cannot be mounted since it collides with the heat sink and cannot be fit into
the FMC connector on the PM3 completely.