Enclume
Décor Maze Pot Rack
Model DR21
DR1
Enclosed you will find everything needed for the assembly and installation of
your new cookware rack. Two people make assembly and installation easier.
The parts and hardware included are:
Hardware included:
4 – Small ceiling screw hooks (for mounting in wood)
4 – 6” lengths of chain
4 – 2”
“S”
hooks
2 – TKC2 ¼”Toggler Kits (for mounting in drywall)
1 – 5/16” Hex key
Components included:
1 – Lower Body
1 – Upper Body
4 – Hanging Straps
12 – Straight Hooks (EPHS)
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1) The lower body and upper body components of your rack have been pre-assembled as experience has told us they are
confusing to put together.
2) Place the rack body on a flat surface and hook the four hanging straps under the body; pull the hangers up to a vertical
position (at right angles to the body).
3) Center the upright hangers on the body in each quadrant of the rack and measure the distances between the hangers.
4) Using these measurements pinpoint and mark mounting holes on your ceiling.
5) We recommend that you anchor your rack into the solid wood of ceiling joists or beams. If one or more your
mounting holes are into wood install the ceiling screw hooks directly into the wood joists. For mounting holes
reaching into drywall you may use the new-technology drywall anchors enclosed with your rack. The steel anchors
are very strong and when installed in drywall will hold 200 lbs. each. To install these anchors please consult the
instructions in the Toggler kits.
6) Install your rack by raising it up and hooking the four tops of the hangers on the ceiling screw hooks.
PLEASE TURN OVER THIS INSTRUCTION
Enclume pot racks are the ultimate
in quality, design, strength and function!
Congratulations for owning one of the finest
Cookware racks made!
WARNING: READ ALL OF THE
INSTRUCTIONS BEFORE ASSEMBLING
AND USING YOUR RACK
Low
e
r Body
Hanging Straps
Upper Body