Users’ Manual
ESM-12S Digital seepage monitoring system
Page
|
13
6 CONFIGURATION WITH ESDL-30 DATALOGGER
6.1 Configuration of ESDL-30 datalogger with ESM-12S sensor with SDI-12 output
NOTE:
For details on operation of model ESDL-30 datalogger, please refer to
Users’ Manual #
WI6002.111.1 on “Operation” of ESDL-30 datalogger.
For details of configuration with
model ESDL-30 datalogger, please refer to
Users’ Manual WI6002.111.2 on “Configuration
Manager for Windows” of ESDL-30 datalogger.
A brief on connection and configuration for model ESM-12S sensor with SDI-12 output is given below.
1. Double click the ESDL-30 datalogger software icon on the Desktop. The main screen of the application
appears as displayed in figure below
2. Connecting Datalogger: Click “Datalogger” followed by “Connect/Disconnect Datalogger”. A
“Connection” window will appear as shown below. Select the usable “Com port” and then click
“Connect”. The progress bar appears on the screen as the application takes few seconds to get
connected.
3. After successful connection, information message pops up on the screen confirming successful
connection. Press “OK” to proceed. This will change “Connection Status”, at the left bottom, from Red
to Green.
Figure 6-2 Connection
