Enarco TIFON 1200, User Manual, Page: 23 / 60

TROWELS TIFON 600/900/1200 WITH PETROL ENGINE
7
en
4
OPERATION AND MAINTENANCE
STARTING PROCEDURE
On all models, operate the safety switch handle and the centrifugal switch handle to keep it
“ON”.
Otherwise, the machine will not start .
PETROL MODELS:
In the 120X and 90X trowels it is necessary to fix the handle or handlebar to the machine .
Mounting the handlebar is very simple, since only the base of the handlebar must be inserted into
the 4 bolts located next to the gearbox. Once in place, put the 4 washers and 4 nuts and firmly
tighten to a torque of 20Nm.
Be sure the fuel
tank is full . Use the recommended gasoline to run the engine from its instruction
book.
Check the engine
oil levels .
Turn the engine stop switch to the position
“ON”.
Open the fuel cock.
Set the speed control lever 1/3 of the way towards the high-speed position.
If the engine is warm or the ambient temperature is high, close the choke lever half way, or keep it
open fully. If the engine is cold, or the ambient temperature is low, close the choke lever.
Pull the starter handle slowly until the resistance is felt. Return the handle to its original position
and pull swiftly.
Allow a longer
warm-up period in cold weather temperatures.
OPERATION
Get into th
e operator’s position behind the centre of the handle. Attain a good feet position and start
the machine. (A)
Push handle down to move the machine right (B), lift handle up to move the machine left gently.
(C)
The machine will remain stationary, it you do not apply any force up and/or down.