Page 10
5.2.1
Installation inside the tree
Preparation:
1)
Prepare a piece of wood with a diameter of 30mm and a length of 10-30 mm.
2)
Drill one 30mm hole into the tree as follows:
3)
Insert the ENAiKOON locate-18 device into the hole. The side with the sticker
must point to the outside of the tree (axial), because this is where the GPS re-
ceiver is mounted.
4)
Insert the 30mm diameter piece of wood into the hole to close and hide it.
5)
Use some dirt to cover the freshly drilled / covered area of the tree
6)
Make sure that the sawdust is not showing potential thieves where the device
was installed
5.2.2
Uninstalling the device
Just remove the 30mm diameter piece of wood from the tree and remove the de-
vice.
Nothing else is required.
We recommend cutting the piece of the tree, which has the hole for ENAiKOON lo-
cate-18 inside, from the tree trunk and dumping it somewhere where it cannot be
found or burning it.
This ensures that unauthorized people will not notice you are using tracking devices
inside trees.