Scan Mode 1:
Scan Mode 1:
Scan Mode 1:
Scan Mode 1: Inverse scanning. Plug a capability switch into Jack 1
located on the rear of the communicator (or use built in switch). Press and
hold the capability switch to scan each of the eight icons. Upon release of
the switch, the communicator will play the message of the cell currently
illuminated.
Scan Mode 2:
Scan Mode 2:
Scan Mode 2:
Scan Mode 2: Automatic scanning. Plug a capability switch into Jack 1
located on the rear of the communicator (or use built in switch). Press the
capability switch for a moment and release. The unit will automatically
scan each of the eight cells and continue scanning until the next press of
the capability switch. It will then play the message of the icon currently
illuminated.
Scan Mode 3:
Scan Mode 3:
Scan Mode 3:
Scan Mode 3: Two switch automatic scanning. Plug a capability switch
into Jack 1 and another capability switch into Jack 2 located on the rear of
the communicator (or use built in switches). Press the capability switch
plugged into Jack 1 for a moment and release. The unit will automatically
scan each of the eight cells continue scanning until the capability switch
that is plugged into Jack 2 is pressed (or built in switch). It will then play
the message of the cell currently illuminated.
Scan Mode 4:
Scan Mode 4:
Scan Mode 4:
Scan Mode 4: Step scanning. Plug a capability switch into Jack 1 and
another capability switch into Jack 2 located on the rear of the
communicator (or use built in switches). Each time the capability switch
that is plugged into Jack 1 (or built in switch) is pressed, it will advance
your selected message to the next cell one at a time. Pressing the
capability switch that is plugged into Jack 2 (or built in switch) will play the
message of the cell currently illuminated.
Scan Speed
Scan Speed
Scan Speed
Scan Speed:
:
:
:
You can control the rate at which the communicator scans the messages
by rotating the SCAN SPEED control located on the bottom panel. Scan
speed can be adjusted from 1 to 25 seconds.
Auditory
Auditory
Auditory
Auditory Cueing
Cueing
Cueing
Cueing:
:
:
:
During Message Scanning you can enable the communicator to speak the
message being scanned, at a reduced volume level. This gives the user an
auditory “preview” of the current message. Pressing the appropriate
capability switch will play the message at full volume. To turn Auditory
Cueing ON or OFF, press the AUD. ON/OFF button located on the
underside of the unit.
The 4 x 5 Communicator has two adjustable feet on the back of the unit,
they will allow you to adjust the angle of the communicator for better
positioning. Turning the feet all the way clockwise well set them at the
lowest height, turning them counter-clockwise will raise the height. See
Photos 1 & 2.
Photo. 1
Photo. 2
Rev
Rev
Rev
Rev 6
6
6
6/1
/1
/1
/1/17
/17
/17
/17
