This product is an accessory or part of a system.
Always read and follow the manufacturer’s
instructions for the equipment you are connecting
this product to. Comply with all applicable codes and safety
regulations. Failure to do so may result in damage, injury or
death!
B
B
P
P
E
E
-
-
5
5
0
0
™
Photo Beam with battery
powered Transmitter
Not UL325 compliant
Operating Instructions
Product Overview
The BPE-50 photo beam system uses 12 -24 VDC/AC on
the transmitter and receiver with the transmitter offering the
option of using the two 3.6 Volt batteries for power
(included).
Recommended battery replacement is the
Varta
ERAA 3V6 2400
.
Technical Specifications
Connections
(Fig 1)
Power Supply
12-24 VDC 24 VAC (2-3.6 Volt Lithium
Batteries for transmitter optional
/included)
Expected battery life up to 2 years
approx.
Current Draw
RX = <50mA standby 100mA activated, TX
= < 500uA
Relay Type
2 Form C DPST contact rating .5A @ 24VDC
/ 120VAC
Temperature
-20C – 55C
Wavelength
880 nm
Frequency
High 90 Hz Low 48 Hz (Ext power 787 Hz)
Environmental
IP 65
Detect Indicator Red LED
Connector
Terminal block
Relay contact
0.5Amp
Housing Material PA6 30% FG
Size
H 4.4in (112mm) x W 2.05in (52mm) x D
1.3in (33mm)
Range
Up to 50 feet (if TX on 12/24 V 90 feet)
Detection Angle
+/- 5%
Sensitivity
Jumper J1 on receiver
Detection delay
< 30 ms
Reset delay
< 120 ms
Transmitter
Receiver
1
Power Positive (+)
Power Positive (+)
2
Power Negative (-)
Power Negative (-)
3
NC Security Contact
(join if not used)
Internal Relay
Normally Open
4
Security edge
(join if not used)
Internal Relay
Common
5
Security edge
(join if not used)
Internal Relay
Normally Closed Output
Terminal connection as viewed from the front, left to right
WARNING …
Not to be used for Personnel Protection
Never use product as sensing devices for personnel protection.
Doing so could cause serious injury or death.
These sensors do NOT include the self-checking redundant circuitry
necessary to allow their use in personnel safety applications. A sensor failure or
malfunction can cause either an energized or de-energized sensor output
condition. UL 325 Non-compliant
