MANUAL
※ Usage
- Connect the charging adapter to the wireless charger.
- When the charging adapter is connected, the first LED lights up.
- Activate the NFC mode of your smartphone.
When the smartphone's NFC (13.56MHz) is activated, the NFC tag
of the cradle is
activated by receiving the induced current from the phone.
(The NFC in this cradle is NFC Tag (
only
passive mode)
.
If you mount a phone
that does not have NFC function, the NFC tag of the cradle does not work and
the wireless charging does not work either.)
- Place the charging target smartphone supporting the WPC standard on the charging
stand as shown below.
- Adjust the charging coil of the smartphone to be centered on the wireless charger.
- When communication with NFC is established, the second LED is turned on and the
content set inside is automatically executed by the smartphone.
- The third LED will be lit when charging is complete, and the color of the LED may
vary depending on the specifications of your smartphone.
- Once the charge is complete, the pink LED will remain on and the charge status will
also be available via the phone charge icon.
- The red LED lights up when charging is not possible or when position adjustment is
required.
- When removing the transparency panel, remove it carefully from the top for the
customer to change the front side picture.
- When inserting new pictures, be careful not to cover the lower sensor part.
LED Description Usage
Summary of Contents for XCAN
Page 4: ......
