Introduction
© 2021 EMP Inc.
4
Introduction
Purpose
The purpose of this quick start guide is to present information related to the pump’s dimensions, electrical
specifications, coolant guidelines, recommended plumbing, mounting orientation, and routine maintenance.
NOTE: For production applications of this product, the full installation specifications must be met. Contact
EMP to request documentation.
Service Technician Responsibilities
Ensure that all safety messages and information messages are read and understood before installation,
maintenance, or repairs are performed. It is important to use caution when service work is performed. Knowledge
of impacted systems and their operation are important before the removal or disassembly of any component.
Liability Disclaimer
EMP cannot anticipate every possible circumstance that might involve a potential hazard. The safety messages
in this document, in related manuals, and on the product are therefore not all inclusive. If a tool, procedure, work
method, or operating technique that is not specifically recommended by EMP is used, you must satisfy yourself
that it is safe for you and for others. You should ensure that the product will not be damaged or be made unsafe
by the operation, maintenance, or repair procedures that you choose.
Additional Information
Access
https://www.emp-corp.com/support/
for service software, service bulletins, service manuals, service
drawings, and other documents related to your installed EMP systems and components. First time users may
create a free customer login at
http://www.emp-corp.com/account/register/
Technical Help
Contact EMP Customer Service for technical help at +1 (906) 789-7497 or
Warnings, Cautions and Notes
Two headings are used in this document to stress your safety and safe operation of the system. They are styled
with a graphic bullet and bold, uppercase text:
WARNING
and
CAUTION
. Warnings highlight risks to
personnel — hazards, unsafe conditions and practices that can result in personal injury or death. Cautions
indicate conditions or practices that can cause damage to components, systems, or other equipment.
A third heading, styled as
NOTE
, calls attention to additional information about components and procedures
discussed in the document.
Definition of Terms
CAN
.............. Controller area network.
EMPower Connect™ service tool
.. EMP service tool for diagnostics via PC.
Ignition Enable
......... An enable signal sent to the controller to turn on. This is separate from power and
ground and should be tied to a switched source and not tied to the pump power.
rpm
............... Revolutions per minute.
!
!