background image

 

USING THE GAS COOKTOP 

 

Pan supports (trivets) 

The trivets were designed to make the cooktop easy and safe to use. We recommend checking 
their exact position and stability on the cooktop before each use.  Furthermore, check that the 
supporting rubbers are integral and correctly positioned. 
 

Small vessel support (Fig.8)  

Only use the auxiliary burner ring (the smallest) for vessels with a small diameter to prevent 
them from tipping and to maximise efficiency. 
 

WOK Burner stand (Fig.9 optional – design may vary to image) 

Only use the wok stand for WOKs (concave bases).  In order to avoid serious burner malfunction, 
we recommend using the wok stand at all times for Woks with curved bases but do not use it for 
vessels with flat bottoms. 
 

Choosing the burner 

Choosing the most adapt burner depends on the vessels’ diameter and capacity (see table). 
It is important that the pan’s diameter matches the burner power to maximise efficiency. 
 

Pan diameter 

Burner 

Minimum diameter 

Maximum diameter 

Auxiliary 

   60 mm

 (with reduction)

 

140 mm 

Semi-rapid 

160 mm 

200 mm 

Rapid 

200 mm 

240 mm 

Triple crown wok  

240 mm 

260 mm 

Dual control 

240 mm 

260 mm 

 

 

 

GAS COOKTOP INSTALLATION  

 

Installation on the kitchen bench 

The cooktop can be installed on materials as long as they are heat-resistant  (minimum 
temperature 100°C).  Clearances from combustable surfaces must be 120mm all around to 
comply with AS5601 regulations. 
 
The size of the hole to be cut into the kitchen bench and the minimum distance between the 
back, side and overhead walls are shown in figures 12, 13, 14, and 15. 
Note that: 

1.  When the cooktop is installed over a vacant cavity (ie without oven below) a separate 

panel must be installed beneath the underside of the cooktop base at a distance of at least 
10 mm. 

2. 

When the cooktop is installed over an oven a divider panel at a minimum distance of 15mm 
is required, and following the oven supplier’s instructions, maintaining ventilation as 
specified in fig. 19. 

 

3.  The electrical connection of the two appliances must be carried out separately. 
4.  We recommend the use of ovens equipped with forced internal cooling such as all models 

from Glem and Emilia. 

 

Summary of Contents for Glem FC64GWI















Reviews: