Emerson Rosemount 8732EM, Reference Manual

Page: 152 / 254

Socket Module—Integral Mount Figure 11-6:
Removing an integral mount socket module
1. Disconnect power.
2. Remove electronics cover to gain access to the coil and electrode cables.
3. If the transmitter has an LOI, it will need to be removed to gain access to the coil and
electrode cables.
4. Disconnect the coil and electrode cables.
5. Remove the four transmitter mounting screws.
6. Lift the transmitter off of the sensor adapter.
7. To remove the socket module, loosen the two mounting screws and pull up on the
socket module from the base.
8. When removing the socket module, do not pull on the wires.
See Figure 11-5 .
Installing an integral mount socket module
1. To insert a new integral mount socket module, press the base into its keyed position
and tighten the two mounting screws.
2. The coil and electrode cables are fed through the bottom opening of the transmitter
and plugged into the face of the electronics.
3. The coil and electrode cables are keyed so they will only fit into their dedicated
location.
4. If the transmitter has an LOI, it will need to be removed to access the coil and
electrode ports.
5. Once the connections are made, the transmitter can be secured to the sensor
adapter using the four mounting bolts.
Maintenance
146 Rosemount ® 8732EM Transmitter with HART Protocol Reference Manual