Emerson Rosemount 5408, Reference Manual

Page: 212 / 274

B.5 FCC
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC ID K8C5408L (for LPR)
K8C5408T (for TLPR)
B.6 IC
This device complies with Industry Canada’s licence-exempt RSS standard. Operation is
subject to the following conditions:
1. This device may not cause interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
3. The installation of the LPR/TLPR device shall be done by trained installers in strict
compliance with the manufacturer’s instructions.
4. The use of this device is on a “no-interference, no-protection” basis. That is, the
user shall accept operations of high-powered radar in the same frequency band
which may interfere with or damage this device. However, devices found to
interfere with primary licensing operations will be required to be removed at the
user’s expense.
5. Devices operating under TLPR conditions (i.e. not operating in “Open Air” Mode)
shall be installed and operated in a completely enclosed container to prevent RF
emissions, which can otherwise interfere with aeronautical navigation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage.
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
Product certifications Reference Manual
February 2020 00809-0100-4408
212 Reference Manual