Emerson Rosemount 2240S, Reference Manual, Page: 169 / 194

159
F
OUNDATION
™
Fieldbus Block Information
F
OUNDATION
™
Fieldbus Block Information
October 2017
Reference Manual
00809-0100-2240, Rev DA
70 PD_TAG PD tag description of device.
71 DEV_STRING This is used to load new licensing into the device. The value can be
written but will always read back with a value of 0.
72 DEV_OPTIONS Indicates which miscellaneous device licensing options are
enabled.
73 OUTPUT_BOARD_SN Output board serial number. For the Rosemount 2230 Display this
is the same as Main Label Device ID which can be found on the main
label that is attached to the housing.
74 FINAL_ASSY_NUM Final assembly number given by manufacturer.
75 DOWNLOAD_MODE Gives access to the boot block code for over-the-wire downloads.
0 = Uninitialized
1 = Run mode
2 = Download mode
76 HEALTH_INDEX Parameter representing the overall health of the device, 100 being
perfect and 1 being non-functioning. The value is based on the
active PWA alarms.
77 FAILED_PRI Designates the alarming priority of the FAILED_ALM and also used
as switch b/w FD and legacy PWA. If value is greater than or equal
to 1 then PWA alerts will be active in device else device will have FD
alerts.
78 RECOMMENDED_ACTION Enumerated list of recommended actions displayed with a device
alert.
79 FAILED_ALM Alarm indicating a failure within a device which makes the device
non-operational.
80 MAINT_ALM Alarm indicating the device needs maintenance soon. If the
condition is ignored, the device will eventually fail.
81 ADVISE_ALM Alarm indicating advisory alarms. These conditions do not have a
direct impact on the process or device integrity.
82 FAILED_ENABLE Enabled FAILED_ALM alarm conditions. Corresponds bit for bit to
the FAILED_ACTIVE. A bit on means that the corresponding alarm
condition is enabled and will be detected. A bit off means the
corresponding alarm condition is disabled and will not be detected.
This parameter is the Read Only copy of FD_FAIL_MAP.
83 FAILED_MASK Mask of FAILED_ALM. Corresponds bit of bit to FAILED_ACTIVE. A
bit on means that the condition is masked out from alarming.
This parameter is the Read Only copy of FD_FAIL_MASK.
84 FAILED_ACTIVE Enumerated list of failure conditions within a device. All open bits
are free to be used as appropriate for each specific device.
This parameter is the Read Only copy of FD_FAIL_ACTIVE.
85 MAINT_PRI Designates the alarming priority of the MAINT_ALM
86 MAINT_ENABLE Enabled MAINT_ALM alarm conditions. Corresponds bit for bit to
the MAINT_ACTIVE. A bit on means that the corresponding alarm
condition is enabled and will be detected. A bit off means the
corresponding alarm condition is disabled and will not be detected.
This parameter is the Read Only copy of FD_OFFSPEC_MAP
87 MAINT_MASK Mask of MAINT_ALM. Corresponds bit of bit to MAINT_ACTIVE. A
bit on means that the condition is masked out from alarming.
This parameter is the Read Only copy of FD_OFFSPEC_MASK.
88 MAINT_ACTIVE Enumerated list of maintenance conditions within a device.
This parameter is the Read Only copy of FD_OFFSPEC_ACTIVE.
Index
Number
Parameter Description