13
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF630
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
5.1
Position the Supply Wires to the left side of the Outlet
Box (Figure 19); position the Fan Wires to the right
side.
Partially insert the RCFP Receiver (flat side up) until
one end rests on the Hanger Ball as shown in
Figure 19.
CAUTION: To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the fan or receiver.
5. How to Wire Your Ceiling Fan
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal injury
or property damage.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
WARNING
!
GREEN GROUND
WIRE FROM
HANGER BRACKET
GROUND
WIRE
GREEN GROUND
WIRE FROM
HANGER BALL
AC IN N
T
O
M
O
T
O
R
N
T
O
M
O
T
O
R
L
AC IN L
F
O
R
L
IG
H
T
Figure 20
AC IN N
AC IN L
T
O
M
O
T
O
R
N
T
O
M
O
T
O
R
L
F
O
R
L
IG
H
T
RCFP
RECEIVER
HANGER
BALL
OUTLET BOX
Figure 19
Refer to Figure 24 for complete wiring diagram.
Connect the Receiver Wires to the Supply Wires and
the Fan Motor Wires as follows:
5.2
Connect the Green Ground Wire from the Hanger Ball
and the Green Ground Wire from the Hanger Bracket
to the Ground Conductor of Supply (this may be a
bare wire or wire with green colored insulation).
Securely connect Wires with Wire Connector
(supplied) (Figure 20).
NOTE: Make all wiring connections using wire
connectors (supplied). Make sure that all
connections are tight, including ground, and that
no bare wire is visible at the wire connectors,
except for the ground wire.