14 – English – rM200
Operating Instructions
Placement
Place the rM200 and monitor near the pipe
entrance so you can manipulate the push
cable while viewing the display. Lay the
rM200 case on its back or position the pull
handle as a kick stand to make sure the
rM200 case does not tip during use.
Use the pull handle as a kick stand when
performing an inspection on a rooftop, hill-
side, or in a location that requires overhead
entry.
Note: Refer to the Handles and Docks sec-
tion for instructions on how to lock the han-
dle into different positions.
Opening the rM200 Case
CAUTION
Make sure the camera is completely in-
side the drum before unlatching and
opening the rM200 case. If the camera
is not in the drum, the push cable can
unwind and cause damage or serious in-
jury.
NOTICE
Do not open the rM200
case while the camera is
stored in the camera clip.
Secure the camera inside
the drum.
Open the rM200 case to install the drum,
replace the bearing, rewind the push cable,
install the docking handle, and to maintain
and clean the rM200 system.
To open the rM200 case, follow these steps:
1. Lock the pull handle against the rear
case.
Note: Refer to the Handles and Docks
section for instructions on how to po-
sition the handle.
2. Remove the stow bin.
Note: Refer to Appendix A for instruc-
tions on how to remove the stow bin.
3. Lay the rM200 case on its back.
4. Secure the camera in the drum by
pushing it through the drum access
opening.
